```

Here are the steps to resolve the issue:

1. Open the failure report mentioned in the output.\
If you don't see the report link in the output in the IDE, make sure to select the top-level node in the structured output panel.
The report will explain the errors in detail.
Perhaps, you forgot to add an `@Incubating` annotation or `@since` in the javadoc.

2. Accept the changes.\

### Relationship between the CLI and controller

The CLI and controller share the same API and codebase for generating manifests from the API. You can think of the
controller as the CLI command `istioctl install` running in a loop in a pod in the cluster and using the config
from the in-cluster IstioOperator custom resource (CR).
There are two major differences:

```

1. Start from the official Python base image.

2. Set the current working directory to `/code`.

    This is where we'll put the `requirements.txt` file and the `app` directory.

3. Copy the file with the requirements to the `/code` directory.

    Copy **only** the file with the requirements first, not the rest of the code.

Similarly, if your TLS certificates do not have the IP SAN for the MinIO server host, the MinIO Console may fail to validate the connection to the server. Use the `MINIO_SERVER_URL` environment variable  and specify the proxy-accessible hostname of the MinIO server to allow the Console to use the MinIO server API using the TLS certificate.

For example: `export MINIO_SERVER_URL="https://minio.example.net"`

replication even before the two sites get fully synced.

In the case of multi destination replication, the replication status shows `COMPLETED` only after the replication operation succeeds on each of the targets specified in the replication configuration. If multiple targets are configured to use active-active replication and multi destination replication, the administrator should ensure that the replication features enabled (such as replica metadata sync, delete marker replication etc) are...

   * <ol>
   *   <li>execution will not stop until the task queue is empty.
   *   <li>tasks will begin execution with the thread marked as not interrupted - any interruption
   *       applies only to the task that was running at the point of interruption.
   *   <li>if the thread was interrupted before the SequentialExecutor's worker begins execution,
   *       the interrupt will be restored to the thread after it completes so that its {@code

namespace.

In the rare event that target DR site is entirely lost and previously replicated objects to the DR cluster need to be re-replicated, `mc replicate resync start alias/bucket --remote-bucket <arn>` can be used to initiate a reset. This would initiate a re-sync between the two clusters by walking the bucket namespace and replicating eligible objects that satisfy the existing objects replication rule specified in the replication config. The status of the resync operation can be viewed with...

/*
Copyright The Kubernetes Authors.

Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at

    http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,

/*
Copyright The Kubernetes Authors.

Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at

    http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,

    }
  }

  /**
   * Attempts to read enough bytes from the stream to fill the given byte array, with the same
   * behavior as {@link DataInput#readFully(byte[])}. Does not close the stream.
   *
   * @param in the input stream to read from.
   * @param b the buffer into which the data is read.
   * @throws EOFException if this stream reaches the end before reading all the bytes.
   * @throws IOException if an I/O error occurs.
   */